Methods to produce PCB At home

Printed circuit board (PCB) is usually a mechanical assembly that consists of layers of fiberglass sheet laminated with etched copper patterns. The fantastic side with PCB is you'll be able to conveniently make it at your house.


To do this you may need: wooden table, copper clad board, glossy photo paper, sharp pen, electric iron, ruler, pencil, hand drill as well as a quantity of quite a few other things.


After you have these issues you need to use a laser printer and an A four photograph paper to take a print from your PCB. When undertaking this you ought to keep in mind to take the mirror print-out. You must also remember to turn off the innovative and optimal printer settings.


You need to then minimize the layout along the boarders and put it within the copper clad board. You ought to then use a ruler and pencil to draw the boarders.


Following executing this you must rub the copper side from the board with scotch brite so as to be sure that PCB is absolutely free from oil or grease. When you have cleaned it you must be careful and make sure that you don't touch the copper surface together with your fingers.


Following performing this you must put some nail polish remover on a tissue paper and after that gently rub the tissue paper within the side of the board. Once more after executing this it is best to be cautious and prevent touching the surface of your board along with your fingers.


You'll want to then transfer the printed picture from the photo paper to your board and put the copper surface of the board over the printed layout. To get to the protected side you need to ensure that the board is aligned correctly along the borders on the printed layout.


To hold the board along with the printed layout in place, you need to reduce 1 or two smaller pieces of cello tape and put them along the 2 sides on the board. You ought to be cautious when doing this and make sure that you area the cello tape around the non-copper side.


The following issue which you ought to do would be to heat up the electrical iron to your maximum temperature and iron the photo paper for about five minutes. You need to be cautious when ironing so as to avoid damaging the photograph paper. In order to avoid damage you'll want to use the tip from the iron to iron.


Immediately after you are performed with the ironing you'll want to place some plain water in on the plastic container and immerse the board into it as a way to amazing down the board. You should then clear away the paper from the PCB utilizing a tooth brush.