Ways to generate PCB In the house

Printed circuit board (PCB) is often a mechanical assembly that includes layers of fiberglass sheet laminated with etched copper patterns. The fantastic side with PCB is you may very easily make it at home.


To try and do this you would like: wooden table, copper clad board, glossy photograph paper, sharp pen, electric iron, ruler, pencil, hand drill and a variety of many other items.


Once you have these matters you need to use a laser printer and an A four photograph paper to take a print out of your PCB. When performing this you ought to keep in mind to consider the mirror print-out. You need to also recall to turn off the superior and optimum printer settings.



You must then lower the layout along the boarders and place it over the copper clad board. You ought to then use a ruler and pencil to draw the boarders.


Following carrying out this it is best to rub the copper side of your board with scotch brite to be able to be sure that PCB is absolutely free from oil or grease. When you have cleaned it you should be careful and ensure that you do not touch the copper surface together with your fingers.


Just after undertaking this you must place some nail polish remover on the tissue paper and after that gently rub the tissue paper about the side of the board. Once more right after carrying out this you'll want to be cautious and keep away from touching the surface on the board together with your fingers.


You'll want to then transfer the printed picture through the photograph paper towards the board and put the copper surface of the board on the printed layout. For being on the risk-free side it is best to be sure that the board is aligned effectively along the borders of your printed layout.


To hold the board and also the printed layout in position, you must cut one particular or two smaller pieces of cello tape and put them along the two sides of the board. It is best to be cautious when executing this and be certain that you location the cello tape to the non-copper side.


The subsequent factor that you simply need to do is usually to heat up the electrical iron for the greatest temperature and iron the photo paper for about 5 minutes. You need to be cautious when ironing so that you can avoid damaging the photo paper. To avoid injury you should use the tip of your iron to iron.


Following you will be carried out using the ironing you'll want to put some plain water in on the plastic container and immerse the board into it in an effort to great down the board. You'll want to then take out the paper from the PCB utilizing a tooth brush.